### What is this? 


This folder contains STL files for parts that I used / designed for the Mouseviator MK4S ECS - Control Panel. Need to write some notes about some of the parts:

Control Panel Housing.stl - This is the biggest component. It gets screwed to the side of the Ikea Lack table and will contain all the panel wiring.
Front Panel.stl - Will get screwed to the housing component.
Panel Handle.stl - A handle that will help lift the front panel from the housing. Print two of these and screw them to the front panel.
Speaker Holder.stl - This part will help to keep active buzzer in place. 

I believe you will figure out how these parts come together, it is not that hard. I am not sure exactly about the screws I used, but I think it was M3 to
mount the front panel to the housing. I've put threaded inserts to plastic into the panel housing using solder. For the handle I think it was M2 and I screwed it
directly to the plastic part.


### What is here?

This zip file should contain the following files and folders:

- Sources - The Autodesk Fusion project with the modeled stuff
- STLs - The STL files for printing the parts
- some pictures so you can actually look what I am writing here about
- This readme file


### License

Just don't resell these files. That would be considered kind of forbidden. They are free. If you reshare elsewhere or further modify them,
would be nice to keep some credits.

### Contact

[admin@mouseviator.com](admin@mouseviator.com)
https://mouseviator.com


